© 2020 IIETA. This article is published by IIETA and is licensed under the CC BY 4.0 license (http://creativecommons.org/licenses/by/4.0/).
OPEN ACCESS
Experimental studies using an X-ray tomography system were performed on a 4-inch horizontal section of the multiphase flow loop at NEL for gas–water and gas–oil–water flows. Values of liquid holdup and water liquid ratio are reported alongside analysis of the phase linear fraction through the cross-section of the pipe. The X-ray system revealed areas of gas entrainment and separation of oil and water which are not evident from high-speed video footage. The flow pattern of the tests was stratified-wavy, and computational fluid dynamics (CFD) analysis was performed using the volume of fluid (VOF) method. The prediction of liquid holdup and gas distribution through the pipe height as determined by CFD, correlated well with that determined by X-ray tomography. however, the results suggest that a transient VOF with a high-order mesh resolution is required to account for gas entrainment. This study shows that an X-ray system can be utilised to provide quantifiable validation data which are of value to multiphase models in CFD and provide insight that is not apparent during high-speed video analysis. The data generated from this system will be of considerable value to multiphase flow specialists and instrumentation developers.
CFD, Multiphase, Void fraction, Tomography, X-Ray
[1] Hall, A.R.W., Flow Patterns in Horizontal Three-Phase Flows of Oil, Water and Gas.Proceedings of Multiphase 1997, 1997.
[2] Beggs, D.H. & Brill, J.P., A Study of Two-Phase Flow in Inclined Pipes. Journal ofPetroleum Technology, 25(5), pp. 607–617, 1973.Figure 9: Results for Test case 218 showing (a and b) X-ray results and(c and d) CFD results.
[3] Baker, O., Simultaneous Flow of Oil and Gas. Oil and Gas Journal, 53, pp. 185–190,1954.
[4] Mandhane, J.M., Gregory, G.A. & Aziz, K., A Flow Pattern Map for Gas-Liquid Flowin Horizontal Pipes. International Journal of Multiphase Flow, 1, pp. 537–553, 1974.
[5] Hill, T.J., Research in multiphase flow developed into new global discipline of flowassurance—an oil industry perspective. Proceedings of the 11th North American Conferenceon Multiphase Technology, 2018.
[6] Hu, B., Langsholt, M., Liu, L., Andersson, P. & Lawrence, C., Flow structure and phasedistribution in stratified and slug flows measured by X-ray tomography. InternationalJournal of Multiphase Flow, 67, pp. 162–179, 2014.
[7] Black, S., Commissioning and Initial Performance of an X-ray tomography Device,NEL Report Number 2018/559, 2019.
[8] Hirt, C.W. & Nichols, B.D., Volume of Fluid (VOF) method for the dynamics of freeboundaries. Journal of Computational Physics, 39(1), pp. 201–225, 1981.
[9] De Schepper, S.C.K., Heynderickx, G.J. & Marin, G.B., CFD modelling of all gas-liquidand vapor-liquid flow regimes predicted by the Baker chart. Chemical EngineeringJournal, 138(1–3), pp. 349–357, 2008.
[10] Parvareh, A., Rahimi, M., Alizadehdakhel, A. & Alsairfai, A.A., CFD and ERTinvestigationson two-phase flow regimes in vertical and horizontal tubes. InternationalCommunications in Heat and Mass Transfer, 37(1), pp. 304–311, 2010.
[11] Brackbill, J.U., Kothe, D.B. & Zemach, C., A Continuum Method for Modelling SurfaceTension. Journal of Computational Physics, 100(1), pp. 335–354,1992.