OPEN ACCESS
Development of the human facial structures including the jaws and dentition occurs in a process that has the characteristics of a complex adaptive system (CAS) influenced by epigenetic, genetic and environmental factors. Earlier studies have suggested dental arch development to be reduced in size in subjects with hypodontia when compared with controls. Hypodontia is a variation of development and presents with a reduced number of teeth together with several other phenotypic changes. This study uses enhanced 3D imaging techniques to increase the accuracy of the measurements of dental arches. The sample consists of orthodontic patients, 60 with hypodontia (thirty males and thirty females), and 60 controls matched for age, gender and ethnicity. One operator using an Amann Girrbach Ceramill Map400 3D scanner recorded the 3D images from dental models. The 3D images were then viewed on MeshLab and the accuracy of the measurements were determined through repeat measurement of the same images; this was undertaken with intra- and inter-operator reproducibility. Ten repeat measurements were taken on 10 different models. Validation of the new system was undertaken by repeating the measurements using the standard 2D caliper technique. Arch dimension measurements were determined from distance between the left-hand side first molar to the right-hand side first molar. Similar measurements were also made for the inter-canine width. The results for average intra-operator measurements were 0.33 mm for the maxillary arch and 0.40 mm for the mandibular arch. The difference in average inter-operator reproducibility was also measured for inter-molar arch dimensions at 0.31 and 0.23 mm for maxillary and mandibular arches, respectively. This novel method provides an increased range of measurement of similar accuracy to standard techniques. This study will proceed to establish the variations on the 3D images between the hypodontia subjects and the control group.
3D imaging, dental arch, hypodontia, measurements, morphology, reliability, repeatability
We are grateful for the participation of the patients in this study, we would also like to acknowledge the assistance and advice of Dr M Sassani and Dr D Haag. We are also grateful to the University of Otago dental laboratory staff for their patience and assistance with this study.
[1] Brook, A.H., O’Donnell, M.B., Hone, A., Hart, E., Hughes, T.E., Smith, R.N. & Townsend, G.C., General and craniofacial development are complex adaptive processes influenced by diversity. Australian Dental Journal, 59, pp. 13–22, 2014.
https://doi.org/10.1111/adj.12158
[2] Wang, J., Sun, K., Shen, Y., Xu, Y., Xie, J., Huang, R., Zhang, Y., Xu, C., Zhang, X., Wang, R. & Lin, Y., DNA methylation is critical for tooth agenesis: implications for sporadic non-syndromic anodontia and hypodontia. Scientific Reports, 6, 19162, 2016. https://doi.org/10.1038/srep19162.
[3] Al Shahrani, I., Togoo, R.A. & AlQarni, M.A., A review of hypodontia: Classification, prevalence, etiology, associated anomalies, clinical implications and treatment options. World Journal of Dentistry, 4(2), pp. 117–125, 2013.
https://doi.org/10.5005/jp-journals-10015-1216
[4] Thesleff I., Current understanding of the process of tooth formation: transfer from the laboratory to the clinic. Australian Dental Journal, 59, pp. 48–54, 2014. https://doi.org/10.1111/adj.12102
[5] Brook, A.H., Koh, K. & Toh, V., Influences in a biological complex adaptive system:
environmental stress affects dental development in a group of Romano-Britons. International Journal of Design & Nature and Ecodynamics, 11(1), pp. 33–40, 2016. https://doi.org/10.2495/dne-v11-n1-33-40
[6] Koh, K., Toh, V., Brook O’Donnell, M., Ranjitkar, S. & Brook, A.H., A complex adaptive system in which environmental stress affects gene expression during development. International Journal of Design & Nature and Ecodynamics, 11(4) pp. 686–695, 2016. https://doi.org/10.2495/dne-v11-n4-686-695
[7] Lam, F., Yong, R., Ranjitkar, S., Townsend, G.C. & Brook, A.H., Agents within a developmental complex adaptive system: intrauterine male hormones influence human tooth size and shape. International Journal of Design & Nature and Ecodynamics, 11(4), pp. 696–702, 2016. https://doi.org/10.2495/dne-v11-n4-696-702
[8] Brook A.H., Jernvall J., Smith R.N., Hughes T.E. &Townsend G.C., The dentition: the outcomes of morphogenesis leading to variations of tooth number, size and shape. Australian Dental Journal, 59(S1), pp. 131–142, 2014.
https://doi.org/10.1111/adj.12160
[9] Polder, B.J., Van’t Hof, M.A., Van der Linden, F.P. & Kuijpers-Jagtman A.M., A meta-analysis of the prevalence of dental agenesis of permanent teeth. Community Dentistry and Oral Epidemiology, 32(3), pp. 217–226, 2004.
https://doi.org/10.1111/j.1600-0528.2004.00158.x
[10] Brook, A.H., Multilevel complex interactions between genetic, epigenetic and environmental factors in the aetiology of anomalies of dental development. Archives Oral Biology, 54S, pp. S3–S17, 2009. https://doi.org/10.1016/j.archoralbio.2009.09.005
[11] Khalaf K., Miskelly J., Voge E. & Macfarlane T.V., Prevalence of hypodontia and associated factors: a systematic review and meta-analysis. Journal of Orthodontics, 41(4), pp. 299–316, 2014. https://doi.org/10.1179/1465313314Y.0000000116
[12] Stevens, D., Mir, C., Nebbe, B., Raboud, D., Heo, G. & Major, P., Validity, reliability, and reproducibility of plaster vs digital study models: Comparison of peer assessment rating and Bolton analysis and their constituent measurements. American Journal Orthodontics and Dentofacial Orthopaedics, 129, pp. 794–803, 2006.
https://doi.org/ 10.1016/j.ajodo.2004.08.023
[13] Bell, A., Ayoub, A. & Siebert, P., Assessment of the accuracy of a three- dimensional imaging system for archiving dental study models. Journal of Orthodontics, 30, pp. 219–223, 2003. https://doi.org/10.1093/ortho/30.3.219
[14] Moreira, D., Gribel, B., Torres, G., Vasconcelos, K., Freitas, D. & Ambrosano, G., Reliability of measurements on virtual models obtained from scanning of impressions and conventional plaster models. Brazilian Journal Oral Science, 13(4), pp. 297–302, 2014. https://doi.org/10.1590/1677-3225v13n4a11
[15] Harris, E.F. & Smith, R.N., Accounting for measurement error: a critical but often overlooked process. Archives of Oral Biology, 54(1), pp. 107–117, 2008. https://doi.org/10.1016/j.archoralbio.2008.04.010
[16] Cicchetti, D., Guidelines, criteria, and rules of thumb for evaluating normed and standardized assessment instruments in psychology. Psychological Assessment, 6(4), pp. 284–290, 1994. https://doi.org/10.1037//1040-3590.6.4.284