OPEN ACCESS
Nowadays, when the energy, industry and transport sectors are adapting to climate change and need to reduce their environmental impact, it is vital that the optimal solutions are found for individual countries and their different circumstances. Territories, which have a hydrocarbon deficit, should use non-conventional energy sources while the countries with substantial resources of hydrocarbons should be focused on the strategy of raising the energy efficiency, i.e. to reduce the specific consumption of fuel consumed. The paper discusses these scenarios and describes some innovative technologies for both cases. Energy production from biomass is encouraged in some European countries by the granting of generous economic subsidies so that renewable energy plants, such as anaerobic digestion plants that produce biogas for use in internal combustion engines, in particular, are receiving much funding. An alternative technology for biogas valorisation could be that of biomethane (so called green gas) production through biogas purification and upgrading processes to remove CO2, H2S and water vapour. Different technologies have been proposed to remove CO2 from gas streams, such as physical absorption, absorption by chemical solvents, cryogenic and membrane separation and CO2 fixation by chemical or biological methods. Production of biomethane and its introduction into the natural gas grid or its use as a fuel for vehicles could increase the energy efficiency and reduce specific emissions (combined cycle gas turbines, district heating of CHP units, methane powered vehicles). A simple and low-cost method of improving energy efficiency and environmental safety of transport by introducing into hydrocarbon fuels micro doses of a universal multifunctional additive is proposed. The method will make a significant contribution towards solving the problems of adapting to global climate change and improving the environment. It is capable of reducing specific fuel consumption by up to 12% and the requirements for a gasoline octane number by 10 points. It significantly reduces emission levels of greenhouse gases and toxic substances and provides complex improvement of the properties of fuels and the condition of engines.
biogas, biomethane, climatic adaptation, energy efficiency, environmental safety, hydrocar- bon fuels, multifunctional additive
[1] Global Material Flows and Resource Productivity: Assessment Report for the UNEP International Resource Panel, 2016.
[2] Genon, G., Panepinto, D. & Viggiano, F., Sustainability in energy production. International Journal of Energy Production and Management, 1(1), pp. 16–32, 2016. https://doi.org/10.2495/EQ-V1-N1-16-32
[3] Ragazzi, M., Ionescu, G. & Cioranu, S.I., Assessment of environmental impact from renewable and non-renewable energy sources. International Journal of Energy Production and Management, 2(1), pp. 8–16, 2017. https://doi.org/10.2495/EQ-V2-N1-8-16
[4] BP Statistical Review of World Energy, 2016.
[5] Cherubini, F., GHG balances of bioenergy systems - overview of key steps in the production chain and methodological concerns. Renewable Energy, 35(7), pp. 1565–1573, 2010. https://doi.org/10.1016/j.renene.2009.11.035
[6] Blengini, G.A., Brizio, E., Cibrario, M. & Genon, G., LCA of bioenergy chains in Piedmont (Italy): a case study to support public decision makers towards sustainability. Resources, Conservation and Recycling, 57, pp. 36–47, 2011. https://doi.org/10.1016/j.resconrec.2011.10.003
[7] Fraunhofer Insitute, Biogas to Energy. Cologne/Oberhausen. Report, 2012.
[8] Patterson, T., Esteves, S., Dinsdale, R. & Guwy, A., Life cycle assessment of biogas infrastructure options on a regional scale. Bioresource Technology, 102(15), pp. 7313–7323, 2011. https://doi.org/10.1016/j.biortech.2011.04.063
[9] Bakonyi, P., Nemestothy, N., Simon, V. & Belafi-Bako, K., Review on the start-up experiences of continuous fermentative hydrogen producing bioreactors. Renewable and Sustainable Energy Reviews, 40, pp. 806–813, 2014. https://doi.org/10.1016/j.rser.2014.08.014
[10] Panepinto, D., Brizio, E. & Genon, G., Atmospheric pollutants and air quality effects: Limitation costs and environment advantages (a cost-benefit approach). Clean Technologies and Environmental Policy, 16(8), pp. 1805–1813, 2014. https://doi.org/10.1007/s10098-014-0727-6
[11] Makaruk, A., Miltner, M. & Harasek, M., Membrane biogas upgrading processes for the production of natural gas substitute. Separation and Purification Technology, 74(1), pp. 83–92, 2010. https://doi.org/10.1016/j.seppur.2010.05.010
[12] Ravina, M. & Genon, G., Global and local emissions of a biogas plant considering the production of biomethane as an alternative end- use solution. Journal of Cleaner Production, 102, pp. 115–126, 2015. https://doi.org/10.1016/j.jclepro.2015.04.056
[13] Panepinto, D., Genon, G., Brizio, E. & Russolillo, D., Production of green energy from co-digestion: perspectives for the province of Cuneo, energetic balance and environmental sustainability. Clean Technologies and Environmental Policy, 15(6), pp. 1055–1062, 2013. https://doi.org/10.1007/s10098-012-0568-0
[14] Ratnesh, T., Chakraborty, M.K. & Tewary, B.K., Generation and dispersion of total suspended particulate matter due to mining activities in an indian opencast coal project, monitoring, control and effects of air pollution, Prof. Andrzej G. Chmielewski (Ed.), ISBN: 978-953-307-526-6, InTech, available at http://www.intechopen.com/books/monitoring-control-and-effects-of-air-pollution/generation-and-dispersion-oftotal-suspended-particulate-matter-due-to-mining-activities-in-an-india
[15] Magaril, E.R., Abrzhina, L.L. & Belyaeva, M.A., Environmental damage from the combustion of fuels: Challenges and methods of economic assessment. WIT Transactions on Ecology and the Environment, 190(2), WIT Press: Southampton and Boston, pp. 1105–1115, 2014.
[16] Boulter, P.G. & Latham, S., Emissions factors 2009: Report 5 – a review of the effects of fuel properties on road vehicle emissions. TRL Report PPR358, TRL Limited, Wokingham, 2009.
[17] Karonis, D., Lois, E., Stournas, S. & Zannikos, F., Correlations of exhaust emissions from a diesel engine with diesel fuel properties. Energy and Fuels, 12(2), pp. 230–238, 1998. https://doi.org/10.1021/ef9700588
[18] Magaril, E., The solution to strategic problems in the oil refining industry as a factor for the sustainable development of automobile transport. WIT Transactions on Ecology and the Environment, 190(2), pp. 821–832, 2014. https://doi.org/10.2495/eq140762
[19] Magaril, E., Increasing the efficiency and environmental safety of vehicle operation through improvement of fuel quality. International Journal of Sustainable Development and Planning, 10(6), pp. 880–893, 2015. https://doi.org/10.2495/SDP-V10-N6-880-893
[20] Magaril, E. & Magaril, R., Fuel quality: challenges to the sustainable development of automobile transport and approach to solution. E3S Web of Conferences, 6, p. 03001, 2016.
[21] Zannis, T.C., Hountalas, D.T., Papagiannakis, R.G. & Levendis, Y.A., Effect of fuel chemical structure and properties on diesel engine performance and pollutant emissions: review of the results of four European research programs. SAE International Journal of Fuels and Lubricants, 1(1), pp. 384–419, 2009. https://doi.org/10.4271/2008-01-0838
[22] Bennett., J., Advanced fuel additives for modern internal combustion engines. Alternative Fuels and Advanced Vehicle Technologies for Improved Environmental Performance. Towards Zero Carbon Transportation, ed. R. Folkson, Woodhead Publishing Ltd: UK, pp 165–194, 2014. https://doi.org/10.1533/9780857097422.1.165
[23] Magaril, E., Improving the efficiency and environmental safety of gasoline engine operation. WIT Transactions on the Built Environment, 130, pp. 437–485, 2013. https://doi.org/10.2495/UT130341
[24] Magaril, E. & Magaril, R., Improving the environmental and performance characteristics of vehicles by introducing the surfactant additive into gasoline. Environmental Science and Pollution Research, 23(17), pp. 17049–17057, 2016. https://doi.org/10.1007/s11356-016-6900-1
[25] Srivastava, S.P. & Hancsók, J., Fuels and Fuel-Additives, John Wiley & Sons Inc: Hoboken, New Jersey, 2014. https://doi.org/10.1002/9781118796214
[26] Magaril, E., Improving car environmental and operational characteristics using a multifunctional fuel additive. WIT Transactions on Ecology and the Environment, 147, pp. 373–384, 2011. https://doi.org/10.2495/air110351
[27] IEA CO2 Emissions from Fuel Combustion, OECD/IEA, Paris, 2016.
[28] Magaril, E., The influence of carbonization elimination on the environmental safety and efficiency of vehicle operation. International Journal of Sustainable Development and Planning, 8(2), pp. 231–245, 2013. https://doi.org/10.2495/SDP-V8-N2-231-245
[29] Magaril, E., Carbon-free gasoline engine operation. International Journal of Sustainable Development and Planning, 10(1), pp. 100–108, 2015. https://doi.org/10.2495/SDP-V10-N1-100-108