Solvent Free Glycolysis of Plastic Waste as Green Corrosion Inhibitor for Carbon Steel in Sulfuric Acid

Solvent Free Glycolysis of Plastic Waste as Green Corrosion Inhibitor for Carbon Steel in Sulfuric Acid

Reda Abdel Hameed

Chemistry Department, Faculty of Science, Al-Azhar University, 11884, Cairo, Egypt

Chemistry Department, Faculty of Science, Hail University, Hail, 1560, KSA

Corresponding Author Email: 
r.abdelghany@uoh.edu.sa, rsabdelhameed@yahoo.com
Page: 
141-149
|
DOI: 
https://doi.org/10.14447/jnmes.v20i3.272
Received: 
8 June 2017
| |
Accepted: 
18 July 2017
| | Citation
Abstract: 

Solvent free efficient green glycolysis of Polyethylene terephthalate waste, PET, in this respect, PET waste was subjected to depolymerization with propylene glycol in the presence of manganese acetate as a catalyst, the product is Bis-(3-hydroxy-propyl)-terephthalate, BHPT, as non-ionic surfactant was separated, characterized by FT-IR and 1HNMR, BHPT was evaluated as corrosion inhibitor for steel in the presence of 1.0 M sulfuric acid by chemical and electrochemical methods, the corrosion inhibition efficiency increase with inhibitor concentration and decrease with temperatures, the galvanostatic polarization curves indicate that the BHPT, compound act as mixed inhibitor, the impedance of the inhibited solution has increased with the increase in the concentration of the inhibitor. the inhibition due to adsorption of the inhibitor molecules on the steel surface, the adsorption obey Langmuir adsorption isotherm. Thermodynamic parameters were computed and discussed, Scanning electron microscope (SEM) was used to study the surface morphology of steel in absence and presence of the used inhibitor, hydrogen evolution techniques was used to evaluate the inhibition efficiency of the BHPT inhibitor compound. the data obtained from different techniques are in good agreement to each other and show the BHPT, surfactant derived from PET, waste considered as good corrosion inhibitor for steel in sulfuric acid.

Keywords: 

green inhibitor, recycling, glycolysis, EIS, polarization, SEM

1. Introduction
2. Experimental
3. Results and Discussion
4. Conclusion
  References

[1] L´opez-Fonseca R., Duque-Ingunza I., De Rivas B., Flores- Giraldo L., Guti´errez-Ortiz J. I., Chemical Engineering Jour-nal, 168, 312 (2011).

[2] Gargiulo C., Belletti G., Presented at Chemical fiber interna-tional, September 1997.

[3] Khoonkari Mohammad, Haghighi Amir Hossein, Sefidbakht Yahya, Shekoohi Khadijeh, and Ghaderian Abolfazl, Interna-tional Journal of Polymer Science,1, (2015).

[4] Colomines G., Robin J., Tersac G., Polymer, 46, 3230 (2005).

[5] Ishihara K., Ishida K., Jpn Pat 11302227; 1999.

[6] Shukla SR., Kulkarni KS. J. Appl. Polym. Sci., 85, 1765 (2002).

[7] Golestani Gh., Shahidi M., Ghazanfari D., Appl. Surf. Sci., 308, 347 (2014).

[8] Hosseini M.G., Ehteshamzadeh M., Shahrabi T., Electrochim. Acta, 52, 3680 (2007).

[9] Abdallah M., Zaafarany I., Khairou K.S., Sobhi M., Int. J. Elec-trochem Soc., 7, 1564 (2012).

[10]Fouda A. S., Abdallah M., Medhat M., Prot. Met. Phys.Chem. Surf., 48, 477 (2012).

[11]Abdallah M., Zaafarany I. A. , AL Jahdaly B.A. , J. Mater. Environ. Sci. 7, 1107 (2016).

[12]Abdelhameed R. S. , , Adv. Appl. Sci. Res., 7, 92 (2016).

[13]Hanane H., Douadi T., Al-Noaimi M., Issaadi S., Daoud D., Chafaa S., Corros. Sci., 88, 234 (2014).

[14]Abdallah M., Asghar B.H., Zaafarany I., Sobhi M., Prot. Met. Phys. Chem. Surf., 49, 485 (2013).

[15]Abdallah M., Al Jahdaly B.A., Al-Malyo O. A., Int. J. Electro-chem Sci., 10, 2740 (2015).

[16]Abdallah M., AL Jahdaly B.A., Sobhi M., Ali A.I., Int. J. Elec-trochem. Sci., 10, 4482 (2015).

[17]Sobhi M., El-Sayed R., Abdallah M., Chem. Eng. Comm., 203, 758 (2016).

[18]Abdel Hameed R. S., Adv. Appl. Sci. Res., 2, 483 ( 2011).

[19]Abdel Hameed R. S., Elmetery Naser S., Alshemary Nawaf F., Shehata H. A., Mat. Sci. J., 14, 417 (2016).

[20]Abdel Hameed R. S., Ph.D., Thesis, Al Azhar Uni., (2006).

[21]Abdel Hameed R. S., Shehata H. A., Abdelbary H.M., Soliman S.A., Salem A.M., Atta A. M., , Mat. Sci. J., 8, 289 (2012).

[22]Abdel Hameed R.S., Al-Shafey H. I. and Farghaly O. A., Re-sear, Rev. Electrochem., 3, 41 (2012).

[23]Abdel Hameed R. S., Al-Shafey H. I., Ismail E. A., Abu-Nawwas Abd-Alhakeem H., El Azabawy O.E.; Int. J. Engi. Res. Applic., 3, 1094 (2013).

[24]Abdel Hameed R.S., El-Zomrawy A., Abdallah M., Abed El Rehim S.S., AlShafey H.I., Nour Edin Sh., Int. J. Corros. Scale Inhib., 6, 196 (2017).

[25]Abdel Hameed R. S., Al Shafey H.I., Abu-Nawwas A.H., Int. J. Electrochem Sci., 9, 6006 (2014).

[26]Abdel Hameed R. S., Al-Shafey H.I., Ismail E.A., Abu-Nawwas Abd-Alhakeem H. Int J Electrochem Sci., 10, 2098 (2015).

[27]Emregul,K. C., Akay A. A., Atakol O., Matter. Chem. Phy., 93, 325 (2005).

[28]Khaled K. F., Electro Chim. Acta, 48, 2493 (2003).

[29]Aljourani J., Raeissi K., Golozar M. A., Corros. Sci., 51, 1836 (2009).

[30]Bhajiwala H. M., Vashi R. T., Bull. Electrochem., 17, 441 (2001).

[31]Schweinsberg D., George G., Nanayakkara A., Steinert D., Corros. Sci., 28, 33 (1988).

[32]Fouda A.S., Moussa M., Taha F. I., ElNeanaa A. I., Corros. Sci., 26, 719 (1986).

[33]Alshafey H.I., Abdel Hameed R.S., Ali F.A., Aboul-Magd Abd El-Aleem S., Salah M.. Inter. J. Pharm. Sci. Revie. Res., 27, 146 (2014).

[34]Singh Kumar Ashish, Kumar Shukla Sudhish, Quraishi M. A., Int J Electrochem Sci., 10, 5802 (2011).

[35]Abd El-Hameed R. S., Port. Electrochim. Acta, 29, 273 (2011).

[36]Al Hamzi A.H., Zarrok H., Zarrouk A., Salghi R., Hammouti B., Al-Deyab S.S., Int. J. Electrochem Sci., 8, 2586 (2013).

[37]Abdel Hameed R. S., Al-Shafey H.I., Abul Magd A.S., Shehata H.A.. J. Mater. Environ. Sci., 3, 294 (2012).

[38]Mansfeld F., Kending M.W., Tsai S., Corrosion, 37, 301 (1981).

[39]Abdallah M., Kamar E. M., Salah Eid , El-Etre A. Y., J Mol. Liq., 220, 755 (2016).

[40]El-Etre A.Y., Ahmed H. Tantawy, Salah Eid, Doaa F. Seyam, J. Basic Envi. Sci., 2, 128 (2017).

[41]Abdel Hameed R. S., Abdallah M., protection of metals and surface chemistry of surface, in press N6 2017.

[42]Abdallah M., Al –Tass H.M., AL Jahdaly B.A., .Fouda A.S, J Mol Liquids, 216, 590 (2016).

[43]Abdel Hameed R. S., Shamroukh A. H., Int. J. Corros. Scale Inhib., 6, 333 (2017).