OPEN ACCESS
Experimental investigation of dispersion from ground source on a single building model was performed. The measurements were conducted in boundary layer wind tunnel in Aerospace Research and Test Establishment (VZLU). Simple rectangular building model, gas flow controllers and flame ionization detectors were used for these experiments. Emissions presented non-buoyant and heavy gases emitted out of a ground-level point source. Tracing gas (ethane) was used for the concentration measurements. Effect of changing source concentration and source distance was studied both on windward and leeward side of the model building. Significant differences between these two basic cases were observed.
Emission dispersion, ground-level source, boundary layer wind tunnel
[1] Eurocode 1: Action on structures – Part 1-4: General actions – Wind loads (EN 1991-1-4). doi: http://dx.doi.org/10.1680/dgte1.31524
[2] Wind tunnel studies of buildings and structures, ASCE manuals and reports on engineering practice No. 67, ed. N. Isyumov, Virginia, 1999.
[3] Ulman, R., Drbohlav, J. & Zachoval, D., Dispersion of harmful gas inside urban area. Proceedings of 7th UK Conference on Wind Engineering, eds. I. Taylor & M. Vezza, Glasgow, pp. 201–204, 2006.
[4] Ulman, R., Physical modeling of heavy gas dispersion inside urban area. VZLU report Nr. R-4837, Prague, 2010.
[5] Jirsak, M. et al., Tlaková a koncentrační měření na modelu 3D budovy k optimalizaci umístění vstupů a výstupů (in Czech). VZLU report Nr. R-4029, Prague, 2006.
[6] Michalek, P. & Zacho, D., Měření nízkých infiltračních průtoků na 3D modelu budovy (in Czech). VZLU report Nr. R-4846, Prague, 2010.
[7] Ulman, R., Janour, Z., Sedenkova, H. & Drbohlav, J., The physical modeling of gas dispersion in topographically complicated terrain. Proceedings of EACWE4, eds. J. Náprstek & C. Fischer, Paper No.189, Prague, 2005.
[8] Jirsak, M. & Ulman, R., Chimney plumes simulation in the boundary layer wind tunnel. Advances in Air Pollution Series XI, WIT Press: Southampton, 2003.
[9] Meroney, R.N., Leitl, B.M., Rafailidis, S. & Schatzmann, M., Wind-tunnel and numerical modeling of flow and dispersion about several building shapes. Journal of Wind Engineering and Industrial Aerodynamics, 81, pp. 333–345, 1999. doi: http://dx.doi.org/10.1016/s0167-6105(99)00028-8
[10] Chavez, M., Hajra, B., Stathopoulos, T. & Bahloul, A., Near-field pollutant dispersion in the built environment by CFD and wind tunnel simulations. Journal of Wind Engineering and Industrial Aerodynamics, 99, pp. 330–339, 2011. doi: http://dx.doi.org/10.1016/j.jweia.2011.01.003
[11] Robins, A., Castro, I., Hayden, P., Steggel, N., Contini, D. & Heist D., A wind tunnel study of dense gas dispersion in a neutral boundary layer over a rough surface. Atmospheric Environment, 35, pp. 2243–2252, 2001. doi: http://dx.doi.org/10.1016/s1352-2310(01)00072-3
[12] Janour, Z., Jurcakova, K., Brych, K., Dittrt, F. & Dittrich F., Potential risks at an industrial site: a wind tunnel study. Process Safety and Environmental Protection, 88, pp. 185–190, 2010. doi: http://dx.doi.org/10.1016/j.psep.2010.01.003
[13] Roberts, P.T. & Fryer-Taylor, R.E.J., Wind-tunnel studies of roughness effects in gas dispersion. Atmospheric Environment, 28(11), pp. 1861–1870, 1994. doi: http://dx.doi.org/10.1016/1352-2310(94)90325-5
[14] Michalek, P. & Zacho, D., Effect of surface roughness on neutral and dense gas dispersion in the BLWT. Air Pollution XX, Ecology and the Environment, volume 157, Paper DOI: 10.2495/AIR120111. doi: http://dx.doi.org/10.2495/air120111