Performance Study of Coal-water Gasification Process in a Texaco Gasifier

Performance Study of Coal-water Gasification Process in a Texaco Gasifier

Zong-ji Li Xi-yong Zhang Yong-qing Lian

Department of Arms Engineering, Navy University of Engineering, Wuhan, Hubei, 430033, China

Page: 
201-204
|
DOI: 
https://doi.org/10.18280/ijht.320129
Received: 
N/A
| |
Accepted: 
N/A
| | Citation

OPEN ACCESS

Abstract: 

In this paper, numerical models of coal-water gasification process are formulated and used to describe coal gasification within Texaco gasifier which is normally used in modern coal power plants. To identify operation performance of Texaco gasifier, Aspen plus software is employed to process the numerical simulation and a typical Chinese coal-Beisu coal-was selected to be dealed with by the gasifier. Important parameters affecting gasifier's gasification performance including coalwater slurry concentration, oxygen-Coal ratio and oxygen concentration are analyzed Numerical results show thatimprovingthe coal-water slurry concentration will significantly increase the contents of active ingredients in raw gas; hydrogen and carbon monoxide, and increasing oxygen-Coal ratio and the concentration of oxygen will decrease their contents.

1. Introduction
2. Gasifier Model
3. Gasification Resllts and Analysis
4. Conclusions
  References

1. Xu, X., Luo, F., Lu, X. The status and progress of coal gasification Co-Production system. (2010). Guangdong Chemical Industry, 37 (7), pp. 85-86.

2. Wang, Y., Li, G., Yu, G. Coal polygeneration is an important direction for the development of clean coal industry. (2010). Inner Mongolia Petrochemical, 9, pp. 45-46.

3. Ni, W., Chen, Z. Clean and efficient use of coal is the key to the low carbon economy of China. (2010). Journal of Taiyuan University of Technology, 41 (5), pp. 456-458.

4. Stiller, C., Thorud, B., Bolland, O., Kandepu, R., Imsland, L. Control strategy for a solid oxide fuel cell and gas turbine hybrid system. (2006). Journal of Power Sources, 158 (1), pp. 303-315.

5. Ni, W., Li, Z., Jiang, H. Analysis of coal-Based generation system. (2003). Coal Conversion, 26 (4), pp. 1-4.

6. Yang, D., Zheshu, M. Conceptual design and performance analysis of waste heat recovery system for intelligent marine diesel engines. Part 1: Impractical analysis of traditional WHR systems. (2012). International Journal of Heat and Technology, 30 (2), pp. 85-91.

7. Zheshu, M., Dong, Y.Conceptual design and performance analysis of waste heat recovery system for intelligent marine diesel engines. part 2: Integrating power turbine into WHR systems. (2012). International Journal of Heat and Technology, 30 (1), pp. 119-125.

8. Ma, Z., Wu, J. Numerical simulation of heat transfer phenomenon in a two- phase closed thermosyphon. (2009). International Journal of Heat and Technology, 27 (1), pp. 75-79.

9. Leng, X., Pan, W., Wang, W., Shen, M., Gu, X., Zhang, L., Hu, S. Development Status of Gasification and its Co-Production System. (2009). Journal of Shanghai University of Electric Power, 25 (2), pp. 117-121.

10. Fu, C., Hang, A. (2009). Chemical Production Technology of Modern Coal, pp. 43-90. Beijing: Chemical Industry Press.

11. Meng, H., Duan, L., Yang, Y. The performance research of the texaco gasifier based on aspen plus. (2008). Modern Electricity, 5 (4), pp. 53-58.