Calcium Cobalt Hexacyanoferrate Cathodes for Rechargeable Divalent Ion Batteries

Calcium Cobalt Hexacyanoferrate Cathodes for Rechargeable Divalent Ion Batteries

Prasanna Padigi Neal Kuperman Joseph James Thiebes* Gary Goncher David Evans Raj Solanki

Department of Physics, Portland State University, SRTC, 1719 SW 10th Ave, SB2-55, Portland, OR 97201, USA

Corresponding Author Email: 
jthiebes@pdx.edu
Page: 
57-64
|
DOI: 
https://doi.org/10.14447/jnmes.v19i2.231
Received: 
15 March 2016
| |
Accepted: 
27 May 2016
| | Citation

OPEN ACCESS

Abstract: 

Calcium cobalt hexacyanoferrate (CaCoHCF) was synthesized and tested as a cathode material for rechargeable batteries, using divalent cations (Mg2+, Ca2+, Ba2+). CaCoHCF demonstrated reversible specific capacity and coulombic efficiency (in parentheses) of 45.49 mAh/g (99.18%) for Mg2+, 55.04 mAh/g (99.2%) for Ca2+, and 44.09 mAh/g (99.42%) for Ba2+, at a current density of 25 mA/g. Of the three ions, Ca2+ resulted in the highest absolute specific capacity as well as high specific capacity utilization. The cathodes were also subjected to rate capability measurements using current densities of 50 mA/g (30 cycles) and 0.1 A/g (100 cycles). Upon addition of 2 mL water to the non-aqueous electrolyte, the fraction of theoretical specific capacity increased to 0.55 for Mg2+, 94.8% for Ca2+, and 95.53% forBa2+. This increase has been interpreted as the ability of the cathode material to intercalate and de-intercalate more ions due to the electrostatic shielding provided by water molecules between the host lattice and the guest cations. An empirical relationship between the cation size and specific capacity utilization is presented.Calcium cobalt hexacyanoferrate (CaCoHCF) was synthesized and tested as a cathode material for rechargeable batteries, using divalent cations (Mg2+, Ca2+, Ba2+). CaCoHCF demonstrated reversible specific capacity and coulombic efficiency (in parentheses) of 45.49 mAh/g (99.18%) for Mg2+, 55.04 mAh/g (99.2%) for Ca2+, and 44.09 mAh/g (99.42%) for Ba2+, at a current density of 25 mA/g. Of the three ions, Ca2+ resulted in highest absolute specific capacity as well as high specific capacity utilization. The cathodes were also subjected to rate capability measurements using current densities of 50 mA/g (30 cycles) and 0.1 A/g (100 cycles). Upon addition of 2 mL water to the non-aqueous electrolyte, the fraction of theoretical specific capacity increased to 0.55 for Mg2+, 94.8% for Ca2+, and 95.53% forBa2+. This increase has been interpreted as the ability of the cathode material to intercalate and de-intercalate more ions due to the electrostatic shielding provided by water molecules between the host lattice and the guest cations. An empirical relationship between the cation size and specific capacity utilization is presented.

Keywords: 

multivalent ion, calcium cobalt hexacyanoferrate, intercalation, rechargeable battery

1. Introduction
2. Experimental Section
3. Results and Discussion
4. Conclusion
5. Acknowledgements
  References

[1] Liu, J.; Xia, H.; Xue, D.; Lu, L. Double-Shelled Nanocapsules of V2O5-Based Composites as High-Performance Anode and Cathode Materials for Li Ion Batteries.J. Am.Chem. Soc.,2009, 131 (34), 12086-12087.

[2] Kim, H.; Jeong, G.; Kim, Y.U.; Kim, J.H.; Park, C.M.; Sohn, H.J. Metallic Anodes for Next Generation Secondary Batteries. Chem. Soc. Rev., 2013, 42 (23), 9011-9034.

[3] Yoo, H. D.; Shterenberg, I.; Gofer, Y.; Gershinsky, G.; Pour, N.; Aurbach, D. Mg Rechargeable Batteries: An On-Going Challenge. Energy Environ. Sci. 2013, 6 (8), 2265-2279.

[4] Padigi, P.; Thiebes, J.; Swan, M.; Goncher, G.; Evans, D.; Solanki, R. Prussian Green: A High Rate Capacity Cathode for Potassium Ion Batteries. Electrochim. Acta, 2015, 166, 32-39.

[5] Padigi, P.; Goncher, G.; Evans, D.; Solanki, R.; Potassium Barium Hexacyanoferrate: A Potential Cathode Material for Rechargeable Calcium Ion Batteries. J. Power Sources, 2015, 273, 460-464.

[6] Levi, E.; Gofer, Y.; Aurbach, D. On the Way to Rechargeable Mg Batteries: The Challenge of New Cathode Materials. Chem. Mater., 2009, 22 (3), 860-868.

[7] Novak, P.; Scheifele, W.; Haas, O. Electrochemical Insertion of Magnesium into Hydrated Vanadium Bronzes. J. Power Sources, 1995, 54, 479.

[8] Crumbliss, A. L.; Lugg, P. S.; Morosoff, N. Alkali Metal Cation Effects in a Prussian Blue Surface-Modified Electrode. Inorg. Chem., 1984, 23, 4701.

[9] Novak, P.; Disilvestro, J. Electrochemical Insertion of Magnesium in Metal Oxides and Sulfides from Aprotic Electrolytes. J. Electrochem. Soc., 1993, 140, 140-144.

[10] Rodríguez-Carvajal, J. “FULLPROF: A Program for Rietveld Refinement and Pattern Matching Analysis.” Abstracts of the Satellite Meeting on Powder Diffraction of the XV Congress of the IUCr, Toulouse, France. 1990, 127.

[11] Bertran, J.F.; Reguera-Ruiz, E.; and Pascual, J.B. The CN Stretch of Hexacyanometallates as a Sensor of Ligand-Outer Cation Interactions-I. Ferricyanides and Cobalticyanides. Spectrochim. Acta, 1990, 46A, 1679-1682.

[12] El Shafei, G.M.S. The Polarizing Power of Metal Cations in (Hydr)Oxides. J. Colloid Interface Sci., 1996, 182, 249-253.

[13] Shannon, R.D. Revised Effective Ionic Radii and Systematic Studies of Interatomic Distances in Halides and Chalcogenides. Acta Crystallogr., Sect. A: Found Crysallogr., 1976, 32, 751-767.